Powertrain Controls Engineer

Job Description:

  • Support specification development as directed and guided by ePT Controls Engineering
  • Participate in Identification of system requirements and operating modes
  • Participate in Identification and rationalization of all op modes
  • Participate in Identification and rationalization of all feasible and useful transition between all operating modes
  • Support specification development as directed and guided by ePT Controls Engineering
  • Participate in Identification of system requirements and operating modes
  • Participate in Identification and rationalization of all op modes
  • Participate in Identification and rationalization of all feasible and useful transition between all operating modes
  • Participate in developing detailed interaction strategy between HCP and relevant charging modules for all steady state operating modes as well as transitions between operating modes
  • Developing detailed documentation of all operating modes and all transitions between operating modes, resulting from above-mentioned activities
  • Developing charging interfaces between HCP and other relevant modules, resulting from above-mentioned activities
  • Developing status/state/mode interface between HCP and other relevant charging modules, resulting from above-mentioned activities
  • Support specification of dbc files and communication gateways
  • Submit change requests for HCP SW to accomplish design intent
  • Definition of new software functionality needed to accomplish interface requirements, resulting from above-mentioned activities
  • Review and correction of FCA documents (CFTS and VF)
  • Support system design specification and requirements
  • Define failure modes and remedial action for HCP charging control modules
  • Develop and document remedial action, resulting from this activity

Requirements:

  • Bachelor of Science in Mechanical or Electrical Engineering is required.
  • Advanced degrees such as MS or PhD preferred
  • 3+ years in powertrain design/release/controls...